Application of laser measuring instrument in ceramic roll industry

Measurement description

1) The laser caliper is fixed on the slide block of the sliding module and can move horizontally along the axial position of the workpiece.

2) One end of the workpiece shaft head is placed on the fixed V-shaped support, and the rotation of the bearing of the V-shaped support drives the rotation of the workpiece; The V-shaped support at the other end can move horizontally along the sliding module to ensure that workpieces of different lengths can be placed for measurement.

3) The control system controls the caliper to move along the axial direction of the workpiece. According to the set position and the number of measurement points, the caliper moves to the set position for detection, the detection is completed, and the measurement results are displayed and stored. (the computer control system sends a signal to the PLC, and the PLC controls the stepping motor to rotate continuously or intermittently to move the caliper along the axial direction of the workpiece. According to the set position and the number of measurement points, the caliper moves to the set position for detection, the detection is completed, and the measurement results are displayed and stored.)

4) Data measured by the measuring instrument: outer diameter, runout, etc. the data can be saved and copied and printed later

3. Measurement index

1) The outer diameter of shaft head support is 17mm ~ 50mm, and the measuring range of outer diameter is 30 ~ 120mm. Accuracy ± (0.005 + 0.02% * measured value) mm.

2) The effective range of tooling is 3.8m.

3) Resolution: 0.001mm; Repeatability: 0.005mm.

4) Tooling * large bearing capacity 80kg.

5) Height from the center of the caliper to the ground: 70mm ~ 90mm.

4. Equipment working conditions

Grid voltage: AC 220V ± 10%, 50Hz

Working environment temperature: 0 ℃ ~ 40 ℃

Working environment humidity ≤ 85%

5. Detection method:

Loading and unloading method: the customer manually places the workpiece.

Detection mode: the workpiece is continuously and automatically detected on the detection device.

Workpiece requirements: no dust, burr and other stains.